|
231 views
|
|
254 viewsNew tranny going in the opposite way it came out. This was my view of wiggling and pushing the tranny into the car, trying to get the lower engine studs to pass through the tranny bell-housing holes as well as having the splines line up on the tranny input shaft.
|
|
259 viewsNew firewall shifter bushing installed (soak in BOILING HOT WATER for ~30-60 seconds, place in hole, put a 24mm socket against it, and hit with hammer). The vice-grips greatly helped get the cabin shift rod into the under-engine shift rod joint.
|
|
253 viewsWhen putting the tranny mounts back together make sure you line up the peg with the hole to keep things from rotating.
|
|
|