 Last additions - Diavel headlight film install |
391 viewsThe 3-pin connector apart. Next up is the 2-pin connector. After that the headlight can come completely off the bike. This is done by pushing the assembly up in the same direction as the fork tubes until the bracket comes off the upper pegs. Pull it forward a little to clear the pegs then downward (if a Strada windshield is in the way) and forward to clear the bike.Mar 15, 2014
|
|
421 viewsFirst, remove the two acorn nuts from the bottom of the headlight fairing. The order is nut, washer, fairing mount, then star-washer. Strada owners should remove the windscreen for easier access to everything. Next, snip the zip-tie on the left side that holds the two cables that feed the headlight. The cable holder is on the frame head. The two headlight cables are below it and towards the center rear of the frame head. That yellowish connector you see below the snips is one of them.Mar 15, 2014
|
|
348 viewsComes with everything you see here, including a knife for trimming excess film off and a very nice water mister. Follow the instructions! I did use the sharp knife to trim the mounting tabs off (they're only used for positioning the film). I placed the film closest to the inside edge of the lens (near the center of the headlight) to get the best coverage.Mar 15, 2014
|
|
358 viewsHow the product comes packaged after you pull it out of the box. Very nice!Mar 15, 2014
|
|
|
|
