 Most viewed - Lubing windows |
504 viewsWhat the window lifter looks like with locating spring attached at bottom.
|
|
486 viewsEither slide the arm out from the bracket or slightly pull down and towards you to release from lifter channel.
|
|
475 viewsI used a Q-Tip to assist greasing the whole lifter channel.
|
|
460 viewsInsert winding mechanisim, lower glass a little, and slide locating spring into lifter channel (wire brush just used to hold window up for picture). Bolt winding mechanisim back to door. Replace everything, including the important vapor barrier (plastic sheet) as this protects the door card from water damage!
|
|
459 viewsUsing a wire brush to clean the channel.
|
|
453 viewsRemove locating spring and wire brush area -- and spring -- clean. Lubricate with grease.
|
|
453 viewsClose-up of back side.
|
|
446 viewsClose-up of front side.
|
|
445 viewsBring winding mechanisim down and keep window glass up.
|
|
443 viewsRemove window crank, door handle release trim (escutcheon), door card (panel) and remove vapor barrier. Remove the four shown bolts with a 10mm wrench.
|
|
|
|
|
|
