AirCooledNut.com

Home > Type 3 > Late model rear seat release

Most viewed - Late model rear seat release
breather_021.jpg
284 viewsAll done and ready for use!
breather_013.jpg
281 viewsUnderside of the seat. What the latch looks like. Under panel removed to show details.
breather_014.jpg
269 viewsSlit in back edge of seat where original pull strap came from. Pass the line through this slit.
breather_016.jpg
268 viewsLine pulled through. Original pull strap can be seen around latch. Typically the strap will break but leave the loop part intact.
breather_020.jpg
261 viewsDrift the hinge pins back in. Tap in with a hammer then use the drift to finish. When inserting or removing the hinge pins it's easiest to drift them in the direction of center-of-car to outside. Applying a thin coat of oil or grease helps insertion and operation of hinge.
breather_017.jpg
255 viewsIf the original strap loop is intact you can loop the line through it. In my case I decided to loop it through the loop and over the latch.
breather_019.jpg
254 viewsPush line back through slit and tie off. I used a simple slip knot with this particular type of line.
 
7 files on 1 page(s)