 Most viewed - CB Performance case breather |
539 viewsHow my case breather is being used. Only one line from the breather and it dumps case over-pressure into the top of the carb.
|
|
478 viewsMesh removed, exposing the inside of the breather. Nothing fancy.
|
|
466 viewsWith the foam removed you can see the expanded metal mesh it rests on. The forward holes are above the mesh while the rear holes are below it.
|
|
464 viewsClose-up of the left side of the breather.
|
|
463 viewsTop removed exposing the foam sponge that traps the oil vapor.
|
|
460 viewsSpirit-level on the shift plate on the shift tunnel to show how much my car is raked. As you can see, it's very mild so the engine is pretty close to the same level as the pan.
|
|
435 viewsSpirit-level on breather to show that it (along with my engine) is at a slight angle. Thus, oil will drain back down into the case through the breather stand (the tower the breather is bolted to).
|
|
427 viewsClose-up of the inside. The bottom edge of the vent is about 5mm from the bottom of the breather.
|
|
395 viewsClose-up of the foam and mesh. Again, nothing fancy. These are the original items.
|
|
|
|
|
|
|
