 Most viewed - LED front parking light |
Day-time, parking lamp only539 viewsComparison of the two bulbs. On the left is the standard incandescent and on the right is the LED unit.
|
|
503 viewsUse a Phillips screwdriver to remove the retaining screw at the bottom of the headlamp. No need to completely remove the screw, just until it becomes loose & wobbly.
|
|
482 viewsComparison of the incandescent bulb (left) and the LED replacement (right).
|
|
In the raw comparison481 viewsComparison of the two bulbs. On the left is the standard incandescent and on the right is the LED unit.
|
|
470 viewsClose-up comparison of the incandescent bulb (left) and the LED replacement (right).
|
|
Fingernails help here.469 viewsPut your fingers between the headlamp bucket and the chrome headlamp ring and pull the bottom of the headlamp out. It only needs to travel a centimeter or two for it to be free. Unhook the top and carefully lay the headlamp on the fluffy towel you placed on the fender (that's a hint).
|
|
469 viewsThe headlamp exposed. Pretty darn simple in there.
|
|
468 viewsThe parking lamp simply pulls straight out. It's a friction-fit retention assembly.
|
|
466 viewsHere's the LED replacement, ready for use.
|
|
456 viewsThough you can watch the video here, it's awfully big so I suggest going to my YouTube page here: http://www.youtube.com/watch?v=ozZp4sLwWhA
|
|
455 viewsThe stock incandescent bulb. Boooo!
|
|
455 viewsThis shows where the retaining clip will rest. Simply put the top of the headlamp ring on the lip of the headlamp bucket and pivot the bottom section down. Make sure the retaining clip fits inside the bottom of the headlamp bucket and then gently push the bottom of the headlamp towards the bike body. Snug retaining screw to secure headlamp but don't over-tighten!
|
|
Night-time, parking lamp only445 viewsComparison of the two bulbs in the dark. On the left is the standard incandescent and on the right is the LED unit.
|
|
|
|
|
|
|
