 Last additions |
136 viewsMay 15, 2018
|
|
135 viewsMay 14, 2018
|
|
112 viewsMay 14, 2018
|
|
104 viewsMay 14, 2018
|
|
103 viewsMay 14, 2018
|
|
101 viewsMay 14, 2018
|
|
105 viewsMay 14, 2018
|
|
101 viewsMay 14, 2018
|
|
102 viewsMay 14, 2018
|
|
103 viewsMay 14, 2018
|
|
101 viewsMay 14, 2018
|
|
102 viewsMay 14, 2018
|
|
101 viewsMay 14, 2018
|
|
103 viewsMay 14, 2018
|
|
102 viewsMay 14, 2018
|
|
112 viewsMay 14, 2018
|
|
112 viewsMay 14, 2018
|
|
307 viewsWill even work for my son's bicycle :-)Jun 17, 2017
|
|
757 viewsHere is my Sport Classic in the new Derek Weaver vise.
I kept the original wheel stop because it is in a stronger mounting location. Using the supplied DW wheel stop would require mounting it on the vertical strip just under the lift bed. That is welded on and could possibly bend if struck too hard when rolling the bike against it. It would also require drilling two more holes...meh, why bother?
https://www.derekweaver.com/bikers-garage/motorcycle-lift-parts-accessories/w-vise-motorcycle-vise-tire-clamp/
Jun 17, 2017
|
|
Mounting measurements319 viewsAll measurements are from the inside boundaries. Final measurements may slightly differ (~1/8") after bolts are tightened. This won't affect operation.
Drilling requires a 1/2" drill bit for metal. All of the holes in the vise parts are on the large side so there is a little bit of room for small tweaks in mounting positioning.
Jun 17, 2017
|
|
| 3279 files on 164 page(s) |
1 |
 |
|
|
