 Most viewed - Grips and TankSlapper install |
The TankSlapper body protection film730 viewsAfter shots of the TankSlapper protection film applied to the tank and my custom application around the ignition switch. 3M film applied to the headlight. The stuff WORKS and can't be seen over a couple feet away. I recommend this stuff to protect your ride!
|
|
Skully grips by Driven658 viewsBefore. Stock grips.
|
|
625 viewsI used a scrap piece of the 3M film to make a surround for the body work around ignition cylinder.
|
|
607 viewsRaw handle bar. Removing the left side is easy. Squirt some Windex(R) under the grip to help loosen its "grip" and make it easier to slip off.
|
|
604 viewsWhat do you do with the left-over stock grips? You could use 'em for handle holders.
|
|
603 views
|
|
602 viewsNapoleon mirror removed.
|
|
580 viewsThe mirror end assembly. Tightening the Allen bolt pulls the nut in, compressing the rubber sleeve and expanding it outward, providing a tight interference fit inside the handle bar.
|
|
578 views
|
|
576 viewsAfter.
|
|
574 viewsNew grip installed.
|
|
565 views
|
|
564 views
|
|
563 views
|
|
561 viewsTo remove, simply loosen the bolt a few turns and pull the whole assembly out.
|
|
551 views
|
|
547 viewsSlide/peel the stock grip off.
|
|
542 viewsThe right grip is held on by a ridge on both ends of the throttle so peel the grip off them.
|
|
542 views
|
|
534 views
|
|
|
|
