 Most viewed |
434 viewsThe end result of the drilling. Yes, the hole is perpendicular.
|
|
434 viewsMeh. Fuzzy picture of the mirror out and the plastic (nylon?) upholstery pry bar tool I used to remove the mirror. Came in a $5 kit from Harbor Freight. Since the mirror was cracked I could've used a steel clawed hammer to remove it.
|
|
434 viewsThis is the back side (duh) of the HEATED, WIDE-ANGLE mirror for the left side-view mirror. This fits the North American vehicles perfectly! Remember to push the electrical connectors on/off several times so they make metal-to-metal contact and coat with a dielectric grease to slow corrosion.
|
|
433 viewsThe builders setting up the galvanized floor framing. I messed up :-( The site wasn't exactly square and I should've expanded the width an additional 3" for a total of 6" per side, left and right, to give a little more spacing between the shed and site walls. But the guys said it's no big deal and, overall, I did a really good job.
|
|
433 viewsOne moment when Morgan was quiet!
|
|
433 views
|
|
433 viewsSouth coast view from inside the lighthouse.
|
|
433 viewsPut the plug wire on the spark plug and figure out how long you need it. This was a short wire and I had half left over. Motorcycle spark plug wires tend to be shorter than your average V8.
|
|
433 viewsParking lights on.
|
|
432 viewsBabies are nice to snuggle up to.
|
|
432 viewsDid you hear what he just said?
|
|
432 viewsWhat we used. Found it at Lowes.
|
|
432 views
|
|
432 viewsMy original pulley lock that I got a previous mechanic to whittle out of steel for me. It's rough but it still serves me well to this day. This is what inspired me to design the newer version, using www.emachineshop.com CAD software and manufacturing.
Though it can be used with the engine out of the car, it makes the job much easier when the engine is in the car and the pulley fan needs to be removed.
|
|
432 views
|
|
432 viewsNew tranny going in the opposite way it came out. This was my view of wiggling and pushing the tranny into the car, trying to get the lower engine studs to pass through the tranny bell-housing holes as well as having the splines line up on the tranny input shaft.
|
|
432 viewsUpper sleeping area inside pop-top has room for two adults as well!
|
|
432 viewsCampers.
|
|
432 views
|
|
432 views
|
|
| 3332 files on 167 page(s) |
 |
63 | |
|
