 Most viewed |
421 viewsMommy playing with Bella in Mimi's room.
|
|
421 viewsGetting the deserts ready.
|
|
421 viewsRonin loved the surf!
|
|
Before and after - against the garage door421 viewsBefore - Low beams.
|
|
421 viewsAfter - Standing next to the B-pillar and looking forward.
|
|
421 viewsSheet of plywood with carpet glued to it removed. Exposed are additional plywood pieces that everything is screwed into. Note that these pieces of plywood are screwed to the Bus floor. I really don't think it's necessary but luckily only a couple screws were used.
|
|
421 viewsUsing a grease pencil to mark the tank where your outline is. This is to help place the pattern later.
|
|
421 viewsThis shows my bike with one protector on. The left side of the picture (right side of bike) is no protector while the right side of the picture (left side of bike) has the fork protector mounted.
|
|
421 views
|
|
421 views
|
|
421 views
|
|
Hmmm...421 viewsThere's about 2-3mm of clearance between the cover and the sprocket retaining nut.
|
|
420 views
|
|
420 views...and finally place the spring and cap on the breather.
|
|
420 viewsAlpacas drinking from a busted sprinkler :-)
|
|
420 viewsDropped!
|
|
420 viewsFloor and back wall up.
|
|
420 viewsClose-up of the single-to-double hitch the previous owner made. I had to use a 1.25" to 2" adapter to pull it behind my Jetta. Was a little squirly even though I went no faster than 60mph. Definitely will be stable once I make a real hitch for my Squareback.
|
|
420 viewsHey, watsa big idea?!
|
|
420 viewsThe decorative cover fits nicely over the unit, hiding it from view.
|
|
| 3332 files on 167 page(s) |
 |
70 | |
|
